Problem
of fewer gaps between compressor bracket and compressor legs analysed.
One should know about stamping schedule .
Stacking of HITACHI armature and 3-phase stator
shown here
Problem of shortage of space and shortage of fixtures,
should be sorted out.
Stamping
work in progress.
Above
picture shows the location of transformer mountingplate-central underframe gap.
This problem can also been reduced by introduction of new quality check
points.
Taking the measurement of axle. These axles are bought from RWF Bangalore. All
Minus variation are rejected.
Wheel
and gear pressing inspection. it may happen that, gear was pressed with 95 Tons, which is less than
100 Tons.
