Work Instruction audit of W21.605 ( Main Pole and
Compole lead terminal brazing) :
Process of silver foil melt filling :
Underframe assembly should not have NC of camber deviation .
The NC of hanging CO2
emission pipe should be attended.
It
was reported that in 3-phase loco traction-bar pang bead
sealant is not being used since long.
A camber
of 15 degree in the middle of the roof will be required with design
section approval.
We should avoid stacking of roofs one over other
continues, which may deform the profile.
With quality control pneumatic copper pipe
failures can be controlled. (like disconnected copper pipes from TRIPLATE panel)
This
problem was again analyzed in the shop.It was found that earlier design of
TRIPLATE panel located on the wall was better as it was less vulnerable to
vibrations.
